ISHWAR BURNING EQUIPMENT
Oil Burning Equipment & Solution Provider
Heating, Pumping and Filtering Units
Heavy fuel oil (Furnace oil) needs preheating from room temperature up to about 100°C in order to reduce its viscosity from 1500 sec to 100 sec Redwood no.1 at 38°C. A constant working pressure of 1 to 3 kg/cm2 is developed for proper firing in fuel oil burners and also to achieve complete combustion in the furnace. Our heating and pumping units (HPUs) are conceived and designed for high thermal efficiency and minimum maintenance cost.
In addition to HPUs, Pumping and Filtering Units (PFUs) are also available without the presence of oil preheaters. These are suitable for firing High Speed Diesel (HSD) or Light Diesel Oil (LDO).
Duplex-2 Heating and Pumping Unit (Horizontal)
Duplex-2 Heating and Pumping Unit (Vertical)
Duplex -1 Heating and Pumping Unit (Vertical)
Simplex type Heating and Pumping Unit (Vertical)
Duplex type Pumping and Filtering Unit
Oil Line Preheaters
Oil line preheaters can be flanged in the line to heat Furnace oil up to 50 °C to reduce its viscosity and facilitate easy flow in the pipeline. In some cases they are used as “booster heater” to bring the temperature of oil to firing level which was earlier cooled down due to pipeline losses. We manufacture heaters in vertical or horizontal mounting design.
Tank Outflow Heaters
Tank outflow heaters can be directly welded to the service / Day tank so that the Furnace oil coming out of the tank gets heated instantly and reduces the load on the motor in the heating unit installed further. Renewable Cartridge type heating elements can be replaced without emptying the Oil tank, as the heater is not in direct contact with the oil.
Thermic Fluid Circulating System
Thermic fluids are used for high temperature (maximum up to 300°C), high volumetric circulation. They constitute low surface load oil preheaters with renewable cartridge type heating elements, thermostats / RTD sensor / PT 100 / digital controllers and special high discharge capacity screw gear pumps/centrifugal pumps, driven by suitable electric motor. Applications are in systems which require heat transfer from a fluid, such as Paper Lamination, Roller Annealing, Plastic Extrusion, etc.
Have questions? We are always to help you questions!
Please fill out the form below with your details and message, and our team will get back to you as soon as possible.